How to stop scrapers?

SteelBuilder500

SteelBuilder500

New member
Messages
19
Hey everyone,

What’s the best way to stop a scraper safely, especially on slopes or in tricky conditions? Any tips for newer operators on handling them properly?
 
Hey @SteelBuilder500, when you're on a slope, make sure to use the parking brake before you get off the machine.
Also, when slowing down, try to ease off the throttle slowly rather than slamming on the brakes, especially in tricky conditions. And if you're on a really steep slope, it might help to have someone spot you for extra safety. Stay safe out there!

By the way, do you usually operate on steep terrain, or is this a new challenge for you?
 
Good question! on slopes, I always downshift early and let the engine do the braking before tapping the service brakes. Smooth and steady is the key, especially when it’s slick or soft.
 
Great tips here about engine braking and steady downshifting are key. I’d add that keeping your load balanced helps a ton on slopes too. Scrapers can get squirrely fast if you rush it!
 
i've always heard the trick is to stay smooth and steady-let the engine do most of the braking and only use the service brakes lightly when you need to.
 
James R. said:
Always wear your seatbelt. Scrapers can be prone to tipping, especially when turning with a high or heavy load.
Click to expand...
You are right, man. always strap in, no exceptions. Those scrapers are just inherently tippy rigs, man. If you've got a heavy load and you crank the wheel while turning, it's looking for an excuse to roll right over. Keep the rubber side down.
 
You must log in or register to reply here.
Back
Top