Search results

My Allis FG95 used to run below 80C but now reaches over 100C. I've cleaned the cooler and checked the thermostat and coolant flow, but the problem persists. What else could be causing it to overheat?

I'm looking for information on dynamic timing adjustment for CAT 3200, 3300, and 3400 engines, especially road-going models.

I'm looking for wiring diagrams covering the battery, ignition switch, starter, alternator, fuel shutoff, relays, and solenoids. Any of these would be helpful.

I'm working on a Case 1150B with a Cummins 451 diesel. Any mechanics here familiar with this engine and common problems to check?

I have a Bobcat 732 with a Ford Pinto engine and need the correct starter. The old starter had a spacer installed. Does anyone know the right starter and spacer setup?

I'm trying to get the cab work lights working on my Hough 910B. I have power at the switch but no lights. Does anyone know where the fuse panel is located?

I'm troubleshooting the driving lights on our 1986 770AH motor grader, but there's no power at the lights or behind the dash. Where can I find the wiring diagrams and fuse locations?

I'm having a valve timing problem on a 450E. The valves are hitting the pistons. What should I check first to find the timing issue?

I'm looking for better traction on muddy job sites. Can I use snow chains or aggressive tread tires, or could that damage the drive motors? Also, should both drive wheels spin in mud, or is it normal for only one to spin?

Hitachi EX120-5 excavator runs fine at idle, but after traveling about 30 meters or using the boom, the engine struggles and stalls. Someone suggested the stepping motor could be the issue. Does it need calibration after replacement, or could this be something else? Has anyone experienced this...

I recently purchased 7FB710 and 7FB711 from Kiewit in Dallas, Texas, and I'm currently shipping them to Australia. I'm interested in learning more about their history, maintenance, and previous work. I'd appreciate any information or experiences you can share.

I'm thinking about buying a 2005 Cat 325C zero-tail-swing excavator and was wondering how difficult they are to service. Is the engine compartment too cramped, or is routine maintenance still fairly straightforward? I'd appreciate any real-world experiences from owners or mechanics.

I have a 1970s Case 350 dozer with a rebuilt engine that has very low hours. The starter turns the engine over very slowly, even after cleaning all the electrical connections and trying a 200-amp battery charger directly on the starter. I'm thinking about replacing it with a gear reduction...

I'm having a hydraulic issue with my Kobelco SK85. The machine bogs down on all hydraulic functions, and when I raise the boom, the dipper slowly creeps out at the same time. If I fully extend the arm, the engine will almost stall. The pumps aren't making any unusual noise, and I've already...

My 2001 Volvo EC240LC started up fine this morning, but the final drive quit working and the bucket curl became extremely slow in both directions. The track will move normally only when I press the auxiliary pedal while tracking. Any ideas on what could cause both issues at once?

I'm working on a Volvo A25C and currently have no headlights, tail lights, brake lights, interior lights, or tachometer working. The machine runs, but it seems like everything related to the electrical side stopped at once. I'm trying to figure out the best place to start checking before...

Mine changes tone when put in gear and also when using the trans disengage switch. I also found some metal and brass shavings in the filter. Could air in the system cause this, or is it pointing to something more serious?

Hey folks, I occasionally haul oversized equipment on a flatbed, and dealing with wide load permits can sometimes be more challenging than the haul itself. How do you handle permits, route planning, and escort requirements in your area, and do you have any tips for making the process smoother?