Search results

My 1991 Versalift VST4000I is leaking hydraulic fluid from the bucket rotator that turns the basket left and right. Has anyone resealed one of these or replaced it before?

My dozer starts and idles but won't rev up, and the blade and tracks won't move. It was running fine until it suddenly idled down and stopped. Has anyone seen these fault codes before?

I'm looking for a replacement oil pressure sensor pigtail connector for my Case 440. The original connector has been spliced before, and there's very little wire left to work with. Does anyone know where I can buy the correct replacement connector or if there's a compatible aftermarket option?

I'm getting a 190-8 code since rebuilding my engine. I already replaced the sensor, but the code is still active. Has anyone run into this after an engine rebuild? I'm trying to figure out what else could be causing it. Any advice would be appreciated.

1997 Cat 345B hydraulic oil leaking into engine oil despite replacing the fan pump twice.

I'm having electrical issues with my JCB 214S. I'm trying to locate all the ground wires on the machine, and I'm also not getting power to the alternator excite wire with the key on. The fuses all check out fine.

I'd start by checking the reference voltage and ground first. A bad ground or weak 5-volt supply can cause all kinds of sensor issues.

I'm having an issue with my 2012 SkyTrak 8042 randomly dropping out of gear. It'll move a few feet, disengage, then re-engage after a few seconds. It seems to happen more when the machine is cold and at low RPM. Once it's warmed up, it runs fine. Has anyone dealt with this before or know what I...

It mostly depends on the machine, site conditions, and local regulations.

For those who've sold equipment there, did your listings attract serious buyers and fast inquiries?

I'm troubleshooting a CAT 627E scraper where transmission oil is migrating into the differential housing. After draining the diff completely and refilling the transmission, oil immediately started flowing into the differential once the machine was started. Trying to figure out if this is...

One of the biggest things with used flatbed trailers is checking the frame and suspension before worrying too much about paint or appearance

I know this is probably a basic question, but I'm still pretty new to running our John Deere 700J and I'm trying to figure out where the starting aid button is located on a 2006 model.

Yeah, they can be noisier and have a little more play, but they're generally viewed as tougher and more reliable for heavy trailers and rough ground

I had the swing pinion shaft snap on my Komatsu PC200-7 and I'm trying to figure out what could have caused it. I replaced the oil seal and had to change the bearings because they were completely seized onto the shaft and would not press out easily.

It can save a lot of time for larger fleets, especially when managing mixed equipment brands.

Good photos, honest machine descriptions, startup videos, service history, and quick replies seem to make a huge difference.

Hmm.. it could be hydraulic holding issues.

I've messed around with SmartEquip a bit, and it's actually pretty solid once you get used to it.

If you use it, just make sure to check the carrier's reviews and insurance before booking.