Recent content by ConcreteKing

Totally agree with Jose! Networking really is key. I’ve had more luck chatting with folks on job sites and union events than any online listing. Anyone here ever land a gig through a Facebook group or local meet-up?

I’ve tried going full DIY warrior on mine with a brush and bucket and felt like I was giving the marble a spa day! 😂 Mild soap, soft brush, and patience go a long way. Anyone ever dared to use a buffer, or is that overkill for outdoor pavers?

If you’re looking for something truly cheap, auctions and private sellers might be your best bet, but be ready for some repairs! Facebook Marketplace and Craigslist sometimes have decent deals if you’re willing to do a little digging. What kind of work do you need it for?

Hey @BricklayerX, Prices are all over the place depending on brand, size, and condition! A new one can easily run $100K+, while a solid used backhoe with decent hours might be in the $30K–$70K range. If you're on a budget, maybe check out brands like JCB or Case it has good value without...

Good call on the teeth—dull ones just slow you down and burn more fuel. I’ve also found that keeping a steady speed and not forcing the cut too deep helps with efficiency. Wirtgen’s been solid for me, but I know some guys swear by CAT. What’s been working best for you?

Yeah, blade configuration can make a big difference! I’ve had good results using staggered carbide teeth for tougher materials, helps cut through concrete without overloading the machine. Also, slowing down just a bit on deep cuts can save wear on the drum. Anyone experimented with different...

Yeah, water flow makes a big difference, especially with mixed materials! I’ve had good luck with Kennametal and Wirtgen blades—they seem to hold up longer on tougher jobs. Anyone tried diamond-tipped teeth for heavy concrete work? Worth the investment?

Yeah, depends on the crane type and location. A small carry deck crane might be a few hundred per day, while a big all-terrain or tower crane can run thousands. As @winston_wisdom said, most places charge a daily minimum, so even if you only need it for a few hours, you’re probably paying for...

In its day, it was a stout little saw. It's a reed valve design, so the RPMs are limited compared to modern saws, but it still had a fair bit of grunt for its size. We still have a rural electric co-op that buys every clean 009 we get in as they prefer them for their bucket saws. They never...

Hey everyone, I’m in the market for a pole saw and could use some recommendations. I’m a homeowner, not a pro, and would likely only use it a few times a year for trimming branches around my property. I don’t want to go super cheap, but I also don’t need top-of-the-line commercial gear...