Search results

  1. jonathan Morris

    Dozer shifts into reverse unexpectedly.

    My 1994 direct-drive dozer suddenly started shifting into reverse while moving forward. Now gears 3 and 4 move in reverse instead of forward. Where should I connect a pressure gauge to check the transmission pressure?
  2. jonathan Morris

    International TD8C power shift transmission creeping in neutral.

    My TD8C dozer creeps even when the pilot valve is in neutral. I rebuilt the pilot valve, but the problem remains. Has anyone rebuilt the regulator valve and found missing springs or balls compared to the service manual?
  3. jonathan Morris

    Can a Gas-Start Diesel Engine Run Directly on Diesel?

    Is it possible to start a gas-start diesel engine directly on diesel by replacing the spark plugs with glow plugs? How important is it to start and shut down the engine on gasoline? Has anyone tried this?
  4. jonathan Morris

    Where can I find Reynolds scraper parts for 17CS and 18CMX models?

    I'm looking for a reliable source for Reynolds 17CS and 18CMX scraper parts. Does anyone know a good supplier for replacement parts?
  5. jonathan Morris

    Where can I find an operator's manual for a 1961 Lorain crane?

    I'm looking for the original or correct operator's manual for a 1961 25-ton Lorain crane mounted on a Coast Crane Carrier truck. Does anyone know where I can find a manual or reliable documentation for this vintage Lorain crane?
  6. jonathan Morris

    Why are the hydraulics not responding on my CAT 313C?

    My 2002 CAT 313C starts and runs normally, but the hydraulics are intermittent and now completely dead. There is no swing, lift, or track movement, while the hydraulic oil level is normal. What could cause this CAT 313C hydraulic control problem?
  7. jonathan Morris

    Where can I find louvered side panels for a 1959 No. 12 grader?

    I'm looking for the louvered side panels for my 1959 No. 12 grader. I need two for the right side and one for the left. Does anyone have a set or know where I can find replacements?
  8. jonathan Morris

    Why is there no fuel reaching the injector lines after an injector pump rebuild?

    I recently had my injector pump rebuilt. Fuel reaches the pump and return line, but nothing comes out through the injector lines. One solenoid has 12V with the key on, while the other has no power. Should both solenoids receive power, and could a relay or fuse be causing this fuel injection problem?
  9. jonathan Morris

    Why does my JLG 943-A telehandler lose power in second gear?

    My JLG 943-A moves fine in first gear, but when I shift into second, it loses power, slows to a crawl, and eventually stops. Where should I start troubleshooting this JLG 943-A transmission or power issue?
  10. jonathan Morris

    Where can I find a RE30815 cylinder assembly for a JD 570B?

    I’m looking for a RE30815 cylinder assembly for my John Deere 570B. I haven’t been able to find one. Does anyone know where I can get this part?
  11. jonathan Morris

    How do I move a New Holland L555 with a dead engine?

    I need to move an old New Holland L555, but the engine won't run. Does it have a parking brake, and how can I release it without engine power?
  12. jonathan Morris

    Where can I find a service manual for a John Deere 570?

    I have the operator’s manual but need a service manual for my John Deere 570 grader. I’m looking for cylinder head installation specs, bolt torque, and torque sequence.
  13. jonathan Morris

    Do I need to prime the hydraulic pump on a Hitachi EX120?

    I replaced the main hydraulic pump on my Hitachi EX120. Do I just fill the hydraulic tank, or does the new pump need to be filled or primed first?
  14. jonathan Morris

    What happened to the Manitex TC85159 boom truck?

    Does anyone know what happened to the Manitex TC85159? It was shown at CONEXPO, but I can’t find current listings or information about the model. Was it discontinued or still in development?
  15. jonathan Morris

    Why does my Kobelco SK200SR veer to the right?

    My Kobelco SK200SR veers right when tracking forward but goes straight when swinging. It also shows an SV3 two-speed solenoid code. Could the travel straight valve be causing this?
  16. jonathan Morris

    Why does the AC on my Cat 631G keep cutting out?

    I'm working on a Cat 631G scraper with an intermittent AC problem. The system works fine when tested but stops cooling after a few hours of operation. Has anyone dealt with a similar Cat 631G AC issue?
  17. jonathan Morris

    Where is the transmission pump on a Cat 950F Series 2?

    I'm new to heavy equipment and need help locating and removing the transmission pump on a Cat 950F Series 2 wheel loader. Any advice would be appreciated.
  18. jonathan Morris

    How do I remove the sprocket on a Komatsu PC200-6?

    I'm trying to remove the sprocket on my Komatsu PC200-6, but the mounting bolts are so close to the sprocket collar that I can't get a socket or wrench on them. What's the best way to remove it?
  19. jonathan Morris

    Why won't my Cat 950G move forward or reverse?

    My Cat 950G wheel loader was working fine but suddenly stopped moving in both forward and reverse. CAT ET shows an active transmission code. What should I check first?
  20. jonathan Morris

    Why is my Cat 950F hydraulic oil overflowing

    I work for a snow removal company, and our Cat 950F is leaking hydraulic oil from the filler cap. The machine was already cooled down, and the oil looks normal. This happened before, too. What could cause the hydraulic oil level to rise?
Back
Top